- #Clover boot usb install
- #Clover boot usb driver
Make a copy of the orig folder and call it USB - i.e. You should now have a folder structure like this (ones in red not required):. Unzip it and then unzip the Clover2k-xxxx-X64.iso file to your C:\temp\Clover\orig folder. Alternatively, download a bootable Clover ISO from here - e.g. Tip: Press 7 immediately after it starts to boot to Clover if you have problems booting. 
You can use this flash drive immediately (on a real system not under QEMU) for testing.Then copy the files from the USB drive to a folder on your system's hard disk - e.g.
#Clover boot usb install
I recommend you download BootDiskUtility and use it to install Clover onto a spare USB Flash drive.
#Clover boot usb driver
It contains boot1F32ALT7 and PBR.BIN files and a modified ist file to show boot圆4.efi entries plus the ntfs.efi driver in the drivers64 folder - or you can make your own version as follows.
I will assume we are only interested in 64-bit booting (the \EFI\CLOVER\BOOTIA32.EFI file and drivers32 folder is required for 32-bit UEFI).Ī ready-made download put together by me is here. Clover will only be able to access USB drives that are connected to a USB 2.0 port (even though you may be able to boot to grub4dos from a USB 3.0 port). The Master Boot Record (MBR) must contain grub4dos boot code. To boot to syslinux, we can then use chainloader /PBR.BIN instead of chainloader +1. The Partition Boot Record (PBR) will need to contain Clover boot code, therefore we need to backup the current PBR boot sector to PBR.BIN. Note that Windows\WindowsPE\Windows Setup cannot access any partition, other than the first one, if the USB drive is a Removable-type flash drive. NTFS) after this first partition if you wish. Most UEFI firmware will only boot from a FAT32 partition if it is the first one on the USB drive. To have the capability of UEFI-booting directly to the Windows installer, the FAT32 partition needs to be the first one - if you always want to boot via Clover from MBR mode, you could put the Clover boot files on a different partition. You could use place the Clover files and PBR on a different FAT32 partition if you wish but you would need to modify the menu.lst file. The UEFI boot files are on the FIRST PRIMARY FAT32 partition of your USB drive.
0 kommentar(er)
